Nano-ZnO film preparation at low temperature and the optical indices calculation

来源 :OptoelectronicsLetters | 被引量 : 0次 | 上传用户:chenhaun0702
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The refractive indices of thin films based on Kramers-Kronig theory are corrected. And the correction theory is used to determine the optical indices of nano-ZnO thin films prepared by low temperature sol-gel method. The calculated results indicate that in the visible (Vis) range, the refractive indices of nano-ZnO thin films exhibit a slight abnormal dispersion, while in the ultraviolet (UV) region, the refractive indices increase with wavelengths increasing (normal dispersion). But the refractive indices show complex change near the absorption edge. The maximum refractive index (1.95) of nano-ZnO thin films within UV range at low temperature annealing is much lower than that of the films annealed at high temperature. The absorption and refractive indices are closely related to the defects in nano-ZnO thin films.
其他文献
激光工艺的最新成就,其成品出售价格较前降低十倍以上,已使激光器跨入重要的商业和工业新应用的门槛。这种感觉是最近美帝《电子学新闻》的记者访问陶恩斯时得到的。
期刊
基于一阶玻恩近似条件,分别得到了标量和电磁平面波经过准均匀(QH)介质散射的二阶强度相关场对比度解析式。解析结果显示,对于标量平面波入射的情况,其对应的强度相关场对比度与散射势强度及比率D/R(D为光纤探头的口径,R为散射体至光纤探头的距离)有关。而对于电磁平面波入射情况,其对应的对比度与散射势强度、入射光偏振度及比率D/R均有关。此外,针对上述两种入射条件下的对比度数值受到各类参量的影响变化关系分别进行了数值仿真研究。仿真结果进一步表明,通过获取强度相关场的对比度数值并利用逆散射问题的求解,可以达到对准
用金属包层介质光波导损耗的微扰理论及藉助多层近似法用递推公式分析渐变折射率波导传播常数的方法,对几种类型的金属包层渐变折射率介质光波导的传输特性与损耗进行分析和讨论,得到了与精确数值计算结果相吻合的结果.
期刊
We have demonstrated a mode matching method between two different fibers by a hybrid thermal expanded core technique, which can be applied to match the modes of fiber-based Fabry–Pérot cavities. Experimentally, this method has achieved an expansion of the
用着色LiF晶体中的色心做红宝石激光器的被动Q开关,得到了能量为50mJ,脉冲宽度为30ns(FWHM)的巨脉冲输出,并和隐花菁(cryptocyanine)等染料调Q作了比较.
期刊
论述了用于宽调谐太赫兹(THz)探测的菲涅耳准相位匹配技术方法的原理,讨论了共振及非共振菲涅耳相位匹配的条件,重点研究了Goos Hanchen延迟对菲涅耳准相位匹配的影响,还讨论了和频过程中有效非线性系数、光波在晶体内全反射角θ的允许宽度及GaAs晶体对互作用三波的吸收,提出了利用角度调谐在菲涅耳相位匹配GaAs晶体中实现宽调谐THz探测的实验设计方案。
期刊
For fabric defect identification in the textile industry, a three-dimensional (3D) color phase shift profilometry (CPSP) method is proposed. The detecting system is mainly composed of one CCD camera and one digital-light-processing (DLP) projector. Before
期刊
期刊