论文部分内容阅读
Structural Characteristics and Photocatalytic Activity of Ambient Pressure Dried SiO2/TiO2 Aerogel C
【机 构】
：
Department of Environmental Engineering, Changzhou University, Changzhou, 213164, China;Institute of
【出 处】
：
武汉理工大学学报（材料科学版）（英文版）
【发表日期】
：
2016年1期
其他文献
Isothermal Crystallization Kinetics of Nylon 10T and Nylon 10T/1010 Copolymers:Effect of Sebacic Aci
Nylon 10T and nylon 10T/1010 samples were synthesized by direct melt polymerization.The isothermal crystallization kinetics of nylon 10T and nylon 10T/1010 was investigated by means of differential scanning calorimetry(DSC).The crystallization kinetics un
Effects of Carbon Nanotubes by Electrophoretic Deposition on Interlaminar Properties of Two Dimensio
Carbon nanotubes (CNTs) were deposited uniformly on carbon cloth by electrophoretic deposition (EPD). Thereafter, CNT-doped clothes were stacked and densified by pyrocarbon via chemical vapor infiltration to fabricate two-dimensional (2D) carbon/carbon (C
Influence of Adding Ti Powder in Preform on Microstructure and Mechanical Properties of Al2O3p/Steel
To improve the mechanical properties of alumina particulates reinforced steel matrix composite, Ti powder was added into the alumina preform, a 5140 steel matrix composite was fabricated by squeeze casting, and the influences of Ti powder on the microstru
Aiming at the problem of available water conservation in desertification ecological restoration, we prepared the water retention materials with montmorillonite(MMT) modified by Castor Oil Polyoxyethylene Ether(10) (EL-10) emulsifying vegetable waxes. The
Characterization of Metal Oxide-modified Walnut-shell Activated Carbon and Its Application for Phosp
We prepared a kind of metal oxide-modified walnut-shell activated carbon (MWAC) by KOH chemical activation method and used for PH3 adsorption removal. Meanwhile, the PH3 adsorption equilibrium was investigated experimentally and fitted by the Toth equatio
An in-situ consolidation method was developed and optimized to successfully fabricate alu-mina ceramics using pre-gelling starch. Our results showed that the obtained ceramics have more homogeneous microstructure, higher density, higher flexural strength,
Influence of Heat Treatment Temperature on Microstructure and Bonding of TiO2 Film Coated on Diamond
TiO2 films were coated on the surface of diamond particles using a sol-gel method. The effects of heat treatment temperature on the morphology, phase composition and chemical bond of diamond particles coated with TiO2 films were investigated through SEM,
Controllable Preparation and Superior Rate Performance of Spinel LiMn2O4 Hollow Microspheres as Cath
Three different curing temperatures (20 ℃, 40 ℃, and 60 ℃) were set, so that the non-evaporable water (wn) contents of plain cement pastes cured at these three temperatures were measured to determine the hydration degree of cement. Tests were carried out