【摘 要】
：
系统地研究了离子半径不同的Ba,Ce,Y作为填充原子及Fe,M作为置换原子对填充化合物RyMxCo4-xSb12晶格热导率的影响规律.结果表明:在skutterudite结构的Sb组成的20面体空洞中,B
【机 构】
：
武汉理工大学材料复合新技术国家重点实验室,上海硅酸盐研究所高性能陶瓷和超微结构国家重点实验室,日本东北大学金属材料研究所
论文部分内容阅读
系统地研究了离子半径不同的Ba,Ce,Y作为填充原子及Fe,M作为置换原子对填充化合物RyMxCo4-xSb12晶格热导率的影响规律.结果表明:在skutterudite结构的Sb组成的20面体空洞中,Ba,Ce,Y的填充原子能显著降低其晶格热导率,且晶格热导率降低幅度按Ba,Ce,Y离子半径减小的顺序而增大.Sb组成的20面体空洞部分被Ba,Ce填充时,晶格热导率最小,填充原子的扰动对声子的散射作用最强.在Co位置上Fe和M的置换,能显著地降低RyMxC2o4-xSb12化合物的晶格热导率,与Fe比,M对晶格热导率的影响更强.
其他文献
Laser surface remelting of medium Ni-Cr infinite chilling cast iron was performed with a continuous wave CO2 laser beam with the power of 7 KW under the argon s
Ordering and atom clustering in aging binary Al-Li alloy has been investigated by computer simulation through calculating the long range order (lro.) parameter
This work reports research concerning the microstructure and sliding wear behaviour of cermet coatings deposited by high velocity oxy-fuel (HVOF) spraying. Two
This paper deals with the kinetics of compound layer growth of steel En40B plasmas nitrided at 520℃ for different time and establishes the corresponding mathem
Degradation phenomena like wear and corrosion, may have their effects accelerated as components operate at high temperature. The aim of this work is to make an
Low cycle fatigue behaviour of a steel 55NiCrMoV7 under four tempered conditions is reported. One special type of total strain controlled isothermal cyclic defo
The development of materials technologies, including surface engineering is one of the main trends in the knowledge-based economy. The direct advantages of the
In order to well design tribosystems of dental CAD-CAM restorations, an understanding of the tribological mechanisms of dental machinable porcelain are essentia
The aging properties of Cu-0.35Cr-0.038Zr-0.055Ce alloy are studied. The results show that can obtain higher electrical conductivity and microhardness after sol
利用双轴加载实验装置和热红外成像仪器对岩石剪切滑移过程中的红外辐射进行了成像实验。研究表明,摩擦速率、正应力、摩擦面粗糙度、岩石强度与矿物颗粒硬度是影响岩石粘滑过程红外辐射的重要因素(1)摩擦以等速率进行时,岩石摩擦裂隙表面平均红外辐射温度的时间曲线为直线型,局部最高温度的时间曲线为3次曲线型,而岩石表面平均红外辐射温度与所受机械功线性相关。当所受机械功相等时,摩擦速率越高,温升幅度越小;(2)红