【摘 要】
：
In order to study the application of laser shock processing(LSP) as a post weld treatment technology and a strengthening technology, a series experiments and an
【机 构】
：
Beijing Aeronautical Manufacturing Technology Research Institute
论文部分内容阅读
In order to study the application of laser shock processing(LSP) as a post weld treatment technology and a strengthening technology, a series experiments and analysis were taken in this paper. The hardness of the laser shock processed zone of Al-Li alloy was measured, and the microstructure and mechanical properties of the welded joints of the Ni-based superalloy GH30 and the Austenitic stainless steel 1Cr18Ni9Ti were compared with those without LSP in this paper. The results showed that the size of strengthened zone was similar to that of laser spot and strengthened layer was about 1mm deep, and the high intense dislocations and twins produced in the shocked zone. Plastic strain also gained surface residual compress stress, which is benefit for the fatigue properties of welded zones. In this test, the surface hardness of welding zone of the superalloy GH30 improved obviously and tensile strength increased by 12%, but the improvement of fatigue life was not obvious; Martensite phase is formed in plasma welding 1Cr18Ni9Ti, which reduced the effect of strain deformation martensite induced by laser shock processing, but the surface residual compress stress gained by laser shock processing can obviously improve the fatigue life of 1Cr1 8Ni9Ti welded joints.
其他文献
电力系统全停或大面积停电后的黑启动策略的研究,是保证整个互联电网安全运行的重要课题.文中综述了黑启动的过程和恢复中存在的问题及相应的解决措施;指出建立自适应的黑启
A series of cubic SiC single crystals were heteroepitaxially grown by the hot-wall chemical vapor deposition (CVD) using a HMDS-C3H8-H2 system on 2 inch silicon
分别以相同面积的光滑 Pt电极和吸附了 Sm3+ 的铂电极作为工作电极 ,在酸性介质中采用循环伏安法对甲醇氧化进行测定 .结果表明 ,吸附了 Sm3+ 的 Pt电极上产生了更大的氧化电
本文报道了微重力条件下90°弯管内气液两相流型实验结果.弯管内径12.7 mm,弯曲半径76.5 mm,气、液两相表观流速分别为1.0～23.6 m/s和0.09～0.5 m/s.本文分析了观测到的弹状流、
In this paper, the study group has researched the comprehensive performance and application of the content of sulfur properly. Based on the research such a conc
The isochronal γ→α transformation of Fe-1Si alloy was measured by high-resolution dilatometry. According to the variation of the ferrite formation rate, an a
Micro-properties of the oxide scale and near-surface zone of a type 316 steel annealed in air and vacuum have been systematically investigated. Microstmctures o
The tribological behaviors were investigated in a new high strength and wear resistant aluminum bronze, with its friction coefficient and wear-rate lower than t
For quenching of age hardenable aluminium alloys today predominantly aqueous quenching media are used.which can lead due to the Leidenfrost phenomenon to a non-
Nitriding of surface of aluminum alloys was carried out with using an electron-beam-excited-plasma (EBEP)technique. The EBEP is sustained by electron impact ion