【摘 要】
：
A network structure surface-enhanced Raman scattering (SERS)-active substrate is fabricated by adding Ag sol dropwise on adhesive tape. Scanning electron microscope (SEM) is employed to characterize the structure of the as-prepared substrate. The substrat
【机 构】
：
DepartmentofMathematicsandPhysics,BeijingInstituteofPetrochemicalTechnology,Beijing102617,ChinaKeyLa
【出 处】
：
OptoelectronicsLetters
论文部分内容阅读
A network structure surface-enhanced Raman scattering (SERS)-active substrate is fabricated by adding Ag sol dropwise on adhesive tape. Scanning electron microscope (SEM) is employed to characterize the structure of the as-prepared substrate. The substrate shows great SERS enhancement ability and good uniformity by using p-aminothiophenol (PATP) as probe molecules. The detection of crystal violet (CV) in aqueous solution is demonstrated, and the detection limit is as low as 10-12 M with the aid of the substrate. The results indicate that the proposed method is a potential approach for the fabrication of SERS substrates.
其他文献
利用简单直观的非近似方法分析双光栅干涉仪,证明了该干涉仪的干涉条纹反差不受照明光源相干性限制时,光源的空间位置不影响条纹形状,仍是等间距直条纹.给出了消除光源相干性限制的一般条件,并讨论了条件失配对干涉仪的影响.
A serial line scan microscopic imaging system with 1 GHz scan rate is proposed and demonstrated. This method is based on optical time-stretch in dispersive fiber to realize superfast scan imaging. Furthermore, a wavelength division technique is utilized t
为了增强光纤通信系统的物理层安全性,提出了一种基于光编/解码技术的新型抗截获通信系统。由于传统地址码的码字容量都相对较小,合法用户使用的地址码容易受到窃听者的强力搜索攻击。一旦用户地址码被获得,光纤信道中传输的所有用户信息将可被窃听者窃取。为了解决这个问题,构造了一种大容量的二维跳频/扩时地址码,并描述了可重构编/解码器的实现方法;设计了一种新型的抗截获通信系统方案,建立了窃听信道模型;最后,利用VPI transmission Maker Optical Systems仿真软件,验证了抗截获通信系统的传
We report a method to reduce the detection delay temperature drift for a single-photon detector based on the avalanche photodiode (SPAD). Both the SPAD and the comparator were temperature stabilized, resulting in an ultra-low temperature drift at 0.01 ps/
Signal degradation due to physical impairments may result in unacceptable bit-error rates of received signals at the destination. Based on earlier work, we study the impairment-aware quality of service (QoS) provisioning problem in dual-header optical bur
通过氢化物气相外延(HVPE)方式在蓝宝石衬底上获得了GaN微米碟,其几何形态为规则的正六边形且表面平整,直径约为27 μm,高度为15 μm。光致发光(PL)实验结果表明,微米碟垂直方向和水平方向的光学谐振模式存在差异,其中水平方向支持回音壁模式(WGM)振荡。在室温条件下采用高能脉冲激光照射微米碟,当激励光功率超过7.8 μW时,PL光谱在波长374 nm附近获得多模式激光信号,其中WGM激光占优势,品质因子可达3742。最后采用COMSOL仿真软件对谐振腔进行光场模拟,并分析了其光学模式特性。
本文从量子力学出发,讨论了面沟道辐射的一般论证.在非简谐近似下,描写了正电子面沟道辐射的频谱辐射.同实验比较表明,二者基本符合.
A high-quality Cr3 :CdWO4 single crystal at a size of approximately \Phi 25 \times 80 mm is grown using the Bridgman method with CdO, WO3, and Cr2O3 as raw materials and their molar ratio of 100:100:0.5. The temperature gradient of solid-liquid interfac
荧光法作为一种非侵入性测量手段,能够实现水体藻类初级生产力的快速测量。然而在目前初级生产力荧光动力学分析中,藻类光合尺寸单元通常采用固定值,导致初级生产力测量结果发生偏差,特别是水体存在蓝藻时尤为明显。光合尺寸单元定义为光合反应中心浓度与叶绿素浓度的比值。为获得准确的水体藻类光合尺寸单元以提高初级生产力测量结果的准确性,利用激发荧光光谱分析水体蓝藻和其他真核藻占比,以此为基础对混合藻样品光合尺寸单元进行校正,并提出一种基于光合尺寸单元校正的荧光法藻类初级生产力测量方法。纯种样品和混合样品初级生产力比对测试