Low-intensity extracorporeal shock wave therapy for Peyronie's disease:a single-center experien

来源 :亚洲男性学杂志(英文版) | 被引量 : 0次 | 上传用户:colinwangaaaa
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The aim of this article is to assess the outcomes of a low-intensity extracorporeal shock wave therapy(LiESWT)protocol for the treatment of Peyronie\'s disease(PD).Patients treated for PD were prospectively recorded,and data were retrospectively reviewed.Age,characteristics of fibrous plaques,concomitant treatments,International Index of Erectile Function(IIEF-5),Lue score,and pain score on Likert scale were collected.Patients in acute phase of PD and an angulation of<40° were included.The protocol consisted of 6 weekly sessions of 4000 pulses each,applied from different directions,with a maximal power of 20 W and 8 Hz frequency.We included 39 patients(median age:56.8 years,interquartile range[IQR]:35.8-62.2 years).The median number of sessions received per patient was 7.2.After treatment,the median Lue score decreased from 6.8 initially to 3.3(P=0.003),the median Likert pain score dropped from 1.8 to 0.7(P=0.004),the median plaque size was reduced from 2 cm to 1.2 cm(P=0.08),and the median penile curvature diminished from 31° to 17°(P=0.07).On univariate and multivariate analysis,the only predictors of success were younger age(odds ratio[OR]=0.95,P=0.03 and OR=0.91,P=0.04,respectively)and concomitant use of phosphodiesterase-5 inhibitors(PDE5i;OR=0.92,P=0.02 and OR=0.93,P=0.01,respectively).LiESWT had a favorable impact on Lue score and notably penile pain,curvature,plaque size,and erectile function in patients treated for PD during the early inflammatory phase,with no side e什fects.Younger age and concomitant use of PDE5i were the only success predictors.
其他文献
目的 针对苏州同心医疗器械有限公司研制的CH-VAD型血泵进行研究,利用血泵中可获得的电压、电流、转速、占空比以及流体的黏度作为输入,建立实时估算血泵流量的方法.方法 将血泵系统拆解为电机和离心泵两个模块单独进行分析.首先根据电机的电压、电流、转速以及占空比计算得到电机的输出力矩,然后通过实验测试在不同转速和黏度下流量与力矩的关系,并根据实验数据建立拟合模型.结果 1、2号血泵拟合优度分别达到0.982 6和0.982 9.利用拟合所得参数进行验证,在黏度变化时,1、2号血泵流量估算的均方根误差分别为0.
以高纯度La2O3、Sm2O3、Nd2O3、Al2O3和Ta2O5为原材料,采用多步高温固相烧结法制备了(La1-xSmxNdx)2AlTaO7陶瓷材料.对其相组成、显微形貌、元素组成物理性能进行了研究.结果 表明,试验合成的氧化物具有单一的氟铝镁钠石结构.其显微组织结构致密,晶界清晰,元素种类和摩尔比与各自的化学式基本一致.由于掺杂增加了声子的散射程度,该类氧化物的热导率明显低于La2AlTaO7,但由于Sm3+和Nd3+的引入降低了氧化物的容许系数,使得(La0.6Sm0.2Nd0.2)2AlTaO7
研究以α-Si3N4和Al2O3为主要粘结剂,采用高温高压(HTHP)烧结制备PCBN复合材料.系统地评价了烧结助剂(Y2O3)添加对PCBN复合材料的显微结构和相关力学性能的影响.结果 表明,在HPHT烧结过程下,加入适量Y2O3的PCBN复合材料的力学性能有了明显的提高.随着烧结助剂的加入,促进了结合剂与cBN之间的界面结合,氮化硅的长径比得到提高.结果 增强了PCBN复合材料的致密性,使复合材料的抗弯强度和硬度增大.1700℃下含有4 wt%Y2O3复合材料相对密度为99.3%,抗弯强度为870.5
采用传统固相法成功制备了不同SiO2掺杂量的ZnO-Bi2O3基压敏陶瓷.研究了SiO2添加剂对ZnO-Bi2O3基压敏陶瓷物相组成、微观形貌和电性能的影响规律及作用机理.XRD结果表明,ZnO-Bi2O3基压敏陶瓷由ZnO主晶相和尖晶石相、富Bi相和含Si相等第二相组成.当SiO2含量增加时,ZnO晶粒尺寸逐渐减小,压敏电压梯度E1mA逐渐增大,这是由于二次相的钉扎效应所致.此外,随着SiO2含量的增加,非线性系数α先增大后减小,而泄漏电流IL先减小后增大,这是由于微观结构变化影响了晶界势垒高度.当Si
To efficiently remove all recurrent lymph nodes(rLNs)and minimize complications,we developed a combination approach that consisted of 68Gallium prostate-specific membrane antigen(PSMA)ligand positron emission tomography(PET)/computed tomography(CT)and int
Male genital tract inflammation/infection and its impact on male fertility are still widely neglected in the workup of male fertility disturbances.Apart from inconsistent definitions of such inflammatory conditions which allow no adequate diagnosis and,co
期刊
内天井是居住类建筑的重要组成部分,本文结合产业园配套公寓的特点,以江门蓬江27号地块激光产业园配套楼建设工程为例,从相关指标及优缺点进行分析,为产业园配套公寓内天井设计提供参考.
Chlamydia trachomatis(CT)infection is the most prevalent sexually transmitted bacterial disease worldwide.However,unlike that in female infertility,the role of CT infection in male infertility remains controversial.The objective of this retrospective stud
为探究风化砂的工程性质,对水泥稳定风化砂进行了力学性能试验,研究了水泥掺量和养护龄期对其抗压强度、劈裂强度和抗压回弹模量的影响,并采用扫描电镜试验对水泥稳定风化砂的微观结构进行分析.结果表明,水泥稳定风化砂抗压强度与时间的关系可以用线性函数y=at+b表示,其中t为养护时间(d).水泥掺量达到3%及以上时,其7d无侧限抗压强度达到规范的要求.水泥的掺量对于劈裂强度的提升具有明显的作用.3%的水泥掺量对稳定风化砂前期抗压回弹模量的提高效果最为显著.SEM结果显示,水泥稳定风化砂结构更为致密,颗粒之间存在着大
采用固相法制备(1-x) N0.5Bi4.5Ti4O15-xBaTiO3 (NBT-BT,x=0,0.05,0.10,0.20,0.30,0.40)高温铋层状压电陶瓷材料.用X射线衍射(XRD)、SEM扫描电镜(SEM),介电和阻抗温谱等测试方法研究了BaTiO3掺杂量对Na0.5Bi4.5Ti4O15陶瓷晶体结构和电性能的影响;结果表明:当x≤0.20时,NBT--BT陶瓷材料为单一的铋层状结构相,居里温度Tc逐渐下降;随着BaTiO3掺杂量的增加,压电常数逐渐增大后逐渐减小,介电损耗变化趋势与之相反,