Optimum design of anti-resonant reflecting photonic crystal vertical-cavity surface-emitting lasers

来源 :ChineseOpticsLetters | 被引量 : 0次 | 上传用户:epwangke96
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Anti-resonant reflecting photonic crystal structure in vertical-cavity surface-emitting lasers (VCSELs) to achieve photon confinement in lateral direction is introduced. This kind of design is proposed to support large aperture single-mode emission. A proper method to fabricate the proposed structure has also been discussed. Firstly a spacer layer will be fabricated between the active layer and pDBR layer. A hexagonal array of high-index cylinders will be designed by etching and re-growth on the spaced layer. The transverse modal property of the proposed structure has been investigated. An optimum design for the minimum radiation loss by considering of the cylinder diameter has been discussed in this paper.
其他文献
Average transmittance of multi-Gaussian (flat-topped and annular) optical beams in an anisotropic turbulent ocean is examined analytically based on the extended Huygens–Fresnel principle. Transmittance variations depending on the link length, anisotropy f
An overview of diagnostic tools e test limiters and collector probes e used over the years for material migration studies in the TEXTOR tokamak is presented. Probe transfer systems are shown and their technical capabilities are described. this is accompan
自第一台气体激光器成功运转以后,气体激光器便迅速向前发展,从现有的波长数、光谱纯度、功率、效率发展的情况来看,其成就远远超过半导体和液体等激光领域,在某些方面还超过了固体激光器。其中特别令人注目的是CO2激光器的发展。
期刊
日本松下电气工业公司中心研究实验室对InGaAsP 二极管激光器和驱动电路在单片InP基片上单片集成已进行了实验验证。驱动电路以异质结双极晶体管为基础。用掩埋式异质结二极管激光器掩埋外延层制成。研制者已经实现了一个关键性的集成指标,即能够高速运转,用集成电路可以以1.6 GHz的速率调制激光输出。
期刊
We demonstrate a high-efficiency, high-power-nanosecond fiber laser-pumped broadband mid-infrared output based on a linearly chirped PPMgLN crystal. By using a linearly polarized pulsed Yb-doped fiber laser as the pump, we experimentally obtain a 1.22-W b
讨论了现有各种点阵全息光刻系统的基本原理。提出了一种基于衍射光栅和空间光调制器数字微反射器(DMD)的点阵全息光刻系统和方法。实现了飞行曝光加工方式,相比现有的步进曝光方式,其加工效率和定位精度获得了大幅度的提升。基于频域分析理论讨论了影响所述光刻系统的分辨率、图形质量和焦深的主要因素。阐述了在该光刻系统中实现飞行曝光加工方式的基本原理。
For space optical remote sensor (SORS) with either film or time delay and integrate charge coupled device (TDI-CCD) imaging, in order to achieve higher resolution it requires more accurate real-time image motion compensation. This primarily depends on rea
设计并研制了全固态连续单频1.34 μm Nd:YVO4环形激光器。利用880 nm激光二极管双端端面偏振抽运Nd:YVO4晶体,通过腔镜镀膜抑制1.06 μm激光振荡和环形激光谐振腔的设计优化使激光器稳定单向行波运转,实验获得了输出功率达9 W的连续单频1.34 μm激光输出,光-光转换效率达18%。激光器在4 h内的功率稳定性优于±1%,在1 min内的频率漂移为8.5 MHz,输出激光的光束质量M2因子为1.03。
以二茂铁甲醇为原料,经Wittig反应后与2,6-(双胺基)-苯并[1,2-d-4,5-d′]双三唑-4,8(2H,6H)-二酮缩合,合成了一个D-π-A-π-D结构的二茂铁席夫碱类金属有机三阶非线性光学材料。化合物结构经1H NMR,MS表征确认。测定了该化合物的紫外可见吸收光谱,用简并四波混频(DFWM)检测了其三阶非线性参数,检测波长为800 nm;脉冲宽度为80 fs。该化合物的三阶非线性极化率χ(3)值为3.67×10-13 esu(静电单位),分子二阶超极化率γ值为3.49×10-31 esu
为聚变应用的大型钕玻璃激光器向更短波长的频率转换,现在正受到很大的注意。理论预言,在短波长下有增加靶对激光束的吸收和更好地把其能量耦合到靶的优点,靶吸收激光能量,产生超热电子,它给燃料预加热。这就使得更难于达到为引燃所需要的高的燃料密度。因此,对于高增益靶就需要较大的靶和高的驱动能量。
期刊