【机 构】
：
KeyLaboratoryforQuantumOptics,ShanghaiInstituteofOpticsandFineMechanics,ChineseAcademyofSciences,Sha
论文部分内容阅读
We experimentally observe polarization spectroscopy (PS) of the S01-P31 transition of mercury atom gases at 253.7 nm. The PS signal can be observed in all six richly abundant isotopes and the PS signal of six transitions for laser cooling are all clear and of a dispersive line shape. The optimized pump power and probe power are found for the PS of Hg202. We find the linearly polarized component in the pump beam will distort the original PS signal due to the use of linear PS. Consequently, the purity of the pump beam is crucial to laser frequency stabilization by PS.
其他文献
提出一种基于边缘检测和Keren配准方法的自适应归一化卷积超分辨率重建算法。为了进一步提高低分辨率序列图像间的配准精度,该算法将边缘检测与Keren配准算法相结合。首先利用Roberts算子对图像序列进行边缘检测,然后利用基于简化四参数仿射变换模型的Keren改进算法求出边缘图像间的平移和旋转参数。仿真实验结果表明即使在含有噪声及大角度旋转情况下,相比Keren改进算法该算法配准精度得到了显著提高
白昼条件下,天空背景光散射强烈,星敏感器在近红外波段工作性能更优,但是由于近红外敏感器件本身特性,近红外星图存在着盐粒噪声、图像非均匀性引起的条纹噪声、背景不均匀性及背景过强等特性,导致难以实现对星图中星点进行有效的提取。为了提高星图星点提取能力,提出了一种结合逆谐波均值滤波、能量相关滤波和形态学滤波的多重滤波方法,先后解决星图盐粒噪声、条纹噪声、背景不均匀性及背景过强等问题,并且利用自适应阈值法
锗和一氧化硅是中波红外区域通常使用的薄膜材料, 研究这些材料的特性, 找到最佳制备工艺并拟合出材料的光学常数, 是设计制备中波红外光学薄膜的关键。最佳工艺条件下, 选用以上两种材料, 以蓝宝石为基底, 设计并制备出中心波长为3.5 μm, 相对带宽4.8%的三腔带通滤光片, 其通带透过率可达80%。经光谱测试和环境可靠性实验结果表明, 该中波红外带通滤光片满足工程使用要求。
In the paper, the results of experimental investigations on the differences of wool structure of healthy mice and mice with malignant tumor(s) are represented. It is shown that destruction of wool structure happens during pathology development. Quantity o
在氟化镁掺镍的晶格中发射红外光子，并产生振荡，称为声子。这种工作物质产生激射作用的波长，部分取决于Ni离子附近晶格的振动，部分取决于离子的电子态。在以往的光激射器中，发射光的波长则取决于电子跃迁。这一发现是贝耳电话实验所的约翰逊（L. F. Johnson)、迪兹（R. E. Dietz)和古根海蒙(H. J. Guggenheim)报导的。由于产生了声子,部分的激发能量被转化为振动能量。
Laser-diode pumped Q-switched ytterbium-doped fiber laser is studied experimentally by controlling the switching time of acousto-optic modulator (AOM). The characteristics of Q-switched pulses with different rise time of AOM regulated by the laser beam si
Retrieving snow surface reflectance is difficult in optical remote sensing. Hence, this letter evaluates five surface reflectance models, including the Ross-Li, Roujean, Walthall, modified Rahman and Staylor models, in terms of their capacities to capture
Realization of efficient yellow-light-emitting diodes (LEDs) has always been a challenge in solid-state lighting. Great effort has been made, but only slight advancements have occurred in the past few decades. After comprehensive work on InGaN-based yello
针对水听器的频响曲线会在透声帽谐振频率处出现共振峰, 使水听器频响曲线失真, 工作频带变窄等问题。本文考虑水听器的工作环境, 通过研究流体-结构相互作用对透声帽谐振频率进行了分析。首先理论分析流体对结构模态频率的影响, 分析显示在流体作用下透声帽谐振频率会降低。然后利用LMS Virtual.lab Acoustics有限元软件对空气中和液体中的MEMS矢量水听器芯片和透声帽进行了模态分析; 并利用振动平台和驻波管对有否进行透声帽封装的MEMS矢量水听器进行了测试以验证上述分析。验证结果显示: 透声帽在水
Metal halide perovskites have aroused tremendous interest in optoelectronics due to their attractive properties, encouraging the development of high-performance devices for emerging application domains such as wearable electronics and the Internet of Thin