【摘 要】
：
The models of stress corrosion,pressure solution and free-face dissolution/precipitation were introduced.Taking a hypothetical nuclear waste repository in an un
【机 构】
：
State Key Laboratory of Geomechanics and Geotechnical Engineering,Technical Centre
【基金项目】
：
The National Key Technology R&D Program of China;国家自然科学基金;国家重点基础研究发展规划(973计划)
论文部分内容阅读
The models of stress corrosion,pressure solution and free-face dissolution/precipitation were introduced.Taking a hypothetical nuclear waste repository in an unsaturated dual-porosity rock mass as the calculation objective,four cases were designed:1) the fracture aperture is a function of stress corrosion,pressure solution and free-face dissolution/precipitation; 2) the fracture aperture changes with stress corrosion and pressure solution; 3) the fracture aperture changes with pressure solution and free-face dissolution/precipitation; 4) the fracture aperture is only a function of pressure solution,and the matrix porosity is also a function of stress in these four cases.Then,the corresponding two-dimensional FEM analyses for the coupled thermo-hydro-mechanical processes were carded out.The results show that the effects of stress corrosion are more prominent than those of pressure solution and free-face dissolution/precipitation,and the fracture aperture and relevant permeability caused by the stress corrosion are only about 1/5 and 1/1000 of the corresponding values created by the pressure solution and free-face dissolution/precipitation,respectively.Under the action of temperature field from released heat,the negative pore and fracture pressures in the computation domain rise continuously,and are inversely proportional to the sealing of fracture aperture.The vector fields of flow velocity of fracture water in the cases with and without considering stress corrosion are obviously different.The differences between the magnitudes and distributions of stresses within the rock mass are very small in all cases.
其他文献
A high Nb containing TiAl alloy was prepared from the pre-alloyed powder of Ti-45Al-8.5Nb-0.2B-0.2W-0.02Y (at％) by spark plasma sintering (SPS).Its high-temperat
Bulk Mn1.2Fe0.8P0.76Ge 0.24 alloy was prepared by mechanical milling and subsequent spark plasma sintering technique.Effect of annealing on the structure and ma
The hot deformation characteristics of as-cast nickel-base superalloy GH742y after hot isostatic pressing (HIP)(hereafter referred to as-cast alloy) have been i
The influence of aging treatment on transformation behavior and shape memory of the Ti50-xNi48Fe2Nbx(x=0,0.6,0.8,1.0,and 1.2)alloys was investigated using diffe
Surface roughness and shape play an important role on the behavior of particles in various processes such as flotation. In this re-search, the influence of diff
The effect of single addition of La or Sm on the microstructures and mechanical properties of an Al-Cu-Mn alloy were investigated by microstructure characteriza
By liquid metal cooling(LMC)process,the Ni-43Ti-4A1-2Nb-2Hf(％,atomic fraction)alloy was directionally solidified(DS).The microstructure and tensile properties at
This paper considers the problem of generating a flight trajectory for a single fixed-wing unmanned combat aerial vehicle (UCAV) performing an air-to-surface mu
Aiming at the reference range selection for different antennas in interferometric inverse synthetic aperture radar (InISAR) systems,this paper proposes a respec
Over the past decade,the interest in aluminum composites reinforced with carbon nanotubes has grown significantly.Studies have been carried out to overcome prob