【摘 要】
：
Optical microscope, X-ray diffractometer, scanning electron microscope, tensile tester and dynamic mechanical analyzer (DMA) were applied to investigate the eff
【机 构】
：
National Engineering Research Center for Magnesium Alloys,College of Materials Science and Engineeri
论文部分内容阅读
Optical microscope, X-ray diffractometer, scanning electron microscope, tensile tester and dynamic mechanical analyzer (DMA) were applied to investigate the effects of Y and Zn additions on microstructure, mechanical properties and damping capacity of Mg-3Cu-1Mn (CM31) alloy. The results show that with the increase of Y and Zn contents, the secondary dendrite arm spacing of alloys is reduced; meanwhile, the yield strength is increased. In low strain amplitude, the damping capacity of alloys with Y and Zn addition is lower than that of CM31 alloy. However, in strain amplitude over 5×10-3, the damping capacity of alloy with a trace of Y and Zn addition (1%Y and 2%Zn, mass fraction) increases abnormally with the increase of strain amplitude and is near to that of pure Mg, probably due to the increase of dislocation density caused by the precipitation of secondary phase. The temperature dependence of damping capacity of above alloy was also tested and discussed.
其他文献
Apatite coating with nanobelt structure was fabricated on single crystal silicon by a two-step method of electrodeposition at 1.0-2.0 mA/cm2 with DC power and v
10% (volume fraction) SiCp/Al-Mg composites with different Mg contents were successfully fabricated by semi-solid mechanical stirring technique under optimum pr
In order to study the effect of the withdrawing rate on carbide morphology, MC-type carbide in single crystal superalloy AM3 was systematically investigated wit
The hot deformation behaviors of solution treated Mg-1.8Mn-0.4Er-0.2Al alloys were investigated by means of compression tests on Gleeble-1500 in strain rate ran
Based on the simulated aerospace thermal cycling tests, the effect of thermal cycle on the void damage evolution mechanism of LF6 aluminum alloy welded joint wa
众所周知文化产业是当今社会发展最快的产业之一，特别是国家的重点扶植和社会的高度关注，都标志着中国文化大发展的新时代开始了。与此同时另一个朝阳产业，也在东北这片黑土地上
To make the ferroelectric BaTiO3 possess ferromagnetism simultaneously, magnetic Fe was doped into BaTiO3 ceramics at doping levels up to 10% (molar fraction).
Four arsenic-resistance genes (arsB, arsC, arsH, arsR) have been discovered in Acidithiobacillus ferrooxidans. Their gene sequences have been identified and thr
Electron beam welding of Ti-15-3 titanium alloy to 304 stainless steel with a copper sheet as interlayer was carried out. Microstructures of the joint were stud
编组站配流问题是研究车站作业计划优化编制的主线，是站调阶段计划的核心．为了实现配流的协同优化，综合考虑解体调机、编组调机、到发线运用、取送车作业、配流等约束，对总车流量