【摘 要】
：
The new 6-switch single-phase 5-level current-source inverter proposed in this paper was developed by properly simplifying the traditional 8-switch single-phase
【机 构】
：
School of Electrical Engineering
论文部分内容阅读
The new 6-switch single-phase 5-level current-source inverter proposed in this paper was developed by properly simplifying the traditional 8-switch single-phase 5-level current-source inverter, and its operational principle was analyzed. Just like the problem of voltage-unbalance between different levels existing in voltage-source multilevel inverters, a similar problem of current-unbalance between different levels whether for the 8-switch single-phase 5-level current-source inverter, or for the new 6-switch 5-level current-source inverter also exists. A simple current-balance control method via DC current feedback is presented here to implement the current-balance control between different levels. And to reduce the output current harmonics, PWM control technique was used. Simulation and experimental results showed that this new 6-switch topology operates correctly and that the balance-inductor can almost equally distribute the total DC current.
其他文献
通过室内蠕变试验和理论分析,对加锚改善岩石流变力学特性进行了研究,并探讨了锚固控制岩石流变的力学机制。采用RLJW-2000型流变试验机,对红砂岩及其加锚试件进行分级加载(1
A kinetic model of the piecewise-linear nonlinear suspension system that consists of a dominant spring and an assistant spring is established.Bifurcation of the
针对当前城市道路网存在的交通拥堵问题,根据城市地面交通的特点和公交优先的原则,利用广义随机Petri网通过将变迁分为时间变迁和瞬时变迁,结合禁止弧和赋予各弧不同的优先权
Based on strength reduction theory, the stability numbers of shallow tunnels were investigated within the framework of upper and lower bound theorems of limit a
The dynamic model experiment of the rock filling embankment was carried out to investigate the vibration compaction mechanism. The rock filling materials were c
To test the influence of binder strength, porous concretes with 4 binder strengths between 30.0-135.0 MPa and 5 void ra tios between 15%-35% were tested. The re
To prepare high wear resistance and high hardness coatings, electro-spark deposition was adopted for depositing an elec trode of a mixture of 92wt%WC+8wt%Co on
Cu-30Ni-xRE (x=0-0.213) alloys were prepared by a metal mould casting method. The effect of RE on the microstructure and mechanical properties of the alloys was
The discrete element method (DEM) was used to simulate the flow characteristic and strength characteristic of the conditioned sands in the earth pressure balanc
Effect of the heat treatment, including solution treatment (ST) and aging treatment (AT), on the prior austenite grain (PAG) size, microstructure and mechanical