【摘 要】
：
The objective of this study is to develop a simple tool for predicting the resonant frequency of the piston mode wave oscillation in a moonpool or a narrow gap between twin floating barges. Based on the dynamic analysis and the domain-decomposition, a lin
【机 构】
：
State Key Laboratory of Coastal and Offshore Engineering, Dalian University of Technology, Dalian 11
论文部分内容阅读
The objective of this study is to develop a simple tool for predicting the resonant frequency of the piston mode wave oscillation in a moonpool or a narrow gap between twin floating barges. Based on the dynamic analysis and the domain-decomposition, a linear harmonic oscillator model for the fluid oscillation in a confined space is formulated, which immediately leads to an explicit dynamic solution for the resonant frequency. In the model, it is assumed that the water depth is equal to or greater than a critical value dependent on the ratio of the draft to the breadth of the floating body. The predicted resonant frequencies are compared with the numerical results of the linear potential model and the viscous fluid model, the semi-analytical potential solutions and the experimental measurements. Good agreements are observed for a wide range of geometric parameters of the moonpool and the narrow gap of either sharp or round edge shapes. The present dynamic method is also applied to predict the resonant frequency of the piston mode oscillation in the gap between a floating body and a vertical wall with a reasonable success.
其他文献
Based on continuum mechanics and rock dynamics, analyzed the micro-structure damage of rock and the impulsive effect under high pressure water jet and developed the dynamic model. Further, on the assumption of that rock was homogeneous and isotropic, a co
A system of on-line contamination detecting in hydraulic oil based on silting principle is accomplished, where, metal filter membrane as detector, solenoid as active force to propel piston to blotter and gain differential pressure, step motor drives the m
By using the Radar penetrating technology and numerical simulations, the fractured zone could be easily determined. Both wall fractured zone and mining action of coal seam roadway were considered, and the bolt reinforcing criteria for wall including low l
It is well known that the formation permeability is not a constant but a function of the in-situ stress environment. This study has been primarily carried out numerically, and to a certain extent, in the field. However, since the rock properties are gener
The structure and principle of the GMM actuator and the new nozzle flapper valve with the GMA were presented. Based on the axis-symmetric FEM model of the GMA,driving magnetic field was computed. And the field distribution for different input currents and
An assistant surface was constructed on the base of boundary that being automatically extracted from the scattered data. The parameters of every data point corresponding to the assistant surface and their applied fields were calculated respectively. In ev
Coal forming environments in the tectonically controlled intermontane Stephanian Cévennes coal basin (Massif central, France) show a complex interelationship between structural and sedimentological features. The study of the general structural features an
Cavitating bubbly flows can form in separated flows and shear layers leading to local regions high vapor void fraction, and these flows often exhibit periodic shedding of vaporous clouds. Historically, the presence of a liquid re-entrant flow, driven by t
Shallow hydrofoils are known to produce lower lift in normal operating conditions in comparison with deep hydrofoils. However, the maximum lift capability of shallow hydrofoils at moderate speeds, which is important for transitional regimes of hydrofoil b
This paper presents an analytical model to solve the linear wave diffraction problem by arrays of bottom-mounted cylinders with arbitrary smooth cross-section. Based on the assumption of ideal fluid and potential theory, the unknown coefficients of total