1976年9月,我厂318车间2~#轧机畏料器滑台中部断裂,被迫停产。滑台总重36吨,长11米,导轨面长9米,机修车间职工在无大批设备的情况下,自力更生解决了滑台加固问题。滑台的前部和后部原是用4个热装环和中部的六个螺钉连为一体的,由于热装环失效导致中部拉裂并凸出20毫米左右。中部接缝处在滑台畏料时受压,在脱管时承受很大的冲击拉力,因此 September 1976, I plant 318 workshop 2 ~ # rolling mill fear central slider, was forced to stop production. Sliding table weighs 36 tons, 11 meters long, 9 meters long rail surface, mechanics shop workers in the absence of large quantities of equipment, self-reliance to solve the problem of landscaping. The front and rear of the slide were originally integrated with four hot-looped rings and six screws in the middle, resulting in a central tear and protrusion of about 20 mm due to a failed hot-ring attachment. The central seams at the slide fear when the material under pressure, when taking off the tube to withstand a lot of impact, so