【摘 要】
：
An ever increasing demand for zinc has resulted in worldwide efforts to exploit complex and lean grade reserves of zinc oxide ore. In this study experiments wer
【机 构】
：
Materials Department,Metallurgical and Materials Department
【基金项目】
：
Yunnan Science and Technology Department
论文部分内容阅读
An ever increasing demand for zinc has resulted in worldwide efforts to exploit complex and lean grade reserves of zinc oxide ore. In this study experiments were done on zinc recovery from high-fluorine bearing zinc oxide ore. First the effect of different variables on fluorine removal was investigated. Optimum experimental conditions occurred when the temperature was 1173 K, roasting time was 90 min and air flow was at a velocity of 5 m/min, the fluorine removal from the samples reached over 93%. The results obtained indicate that fluorine removal is not enhanced by adding diluted sulfuric acid or water as a binder. Second the roasted materials were leached with a diluted sulfuric acid,neutralized, flocculated and filtrated. The residual fluorine content in the leached solutions was less than 38 mg/L,which satisfies the requirement of fluorine content in the leached solutions for the production of electrolytic zinc.
其他文献
This paper presents an automatic non-photorealistic rendering approach to generating technical illustration from 3D models. It first decomposes the 3D object in
The proton exchange membrane generation technology is highly efficient and clean, and is considered as the most hopeful "green" power technology. The operating
Rare earth co-permeation of (N H4)3 [CrMo6 O24 H6]·7H2O was reported and the conductivity of (N H4)3 [CrMo6O24 H6]was improved by 6.734× 109 times. X-ray fluo
Tungsten films were deposited on stainless steel Charpy specimens by magnetron sputtering followed by electron beam heat treatment. Charpy impact tests and scan
In this study we conducted single V-groove butt welding (GTAW) on three types of heat treatable aluminum alloys 2024-T351, 6061-T6 and 7075-T6 and compared the
Carbon nanofiber (CNF)-reinforced polypropylene (CNF/PP) composites with different CNF contents were prepared by melt mixing, and the mechanical properties and
在我国较为落后的品牌竞争意识下,不可避免地形成竞争误区,为此有四方面的对策:一是将品牌策略融入企业战略中;二是注重以质取胜;三是开展多种营销方式;四是建立良好的客户关
TC4 titanium alloy was welded by double-sided gas tungsten arc welding(GTAW) process in comparison with conventional GTAW process, the microstructure and mechan
Gold nanoparticles dispersed Y2O3 films were prepared through a sol-gel method by using yttrium acetate and Au nanoparticles colloid as precursors. The films we
A continuous loading push-out test technique was used to measure the interfacial shear strength of SiC fiber reinforced Ti matrix composites. The interracial sh