【摘 要】
：
The random walk particle tracking (RWPT) method is compared with the Eulerian methods in investigating pollutant transport in depth-averaged flows.As a typical representative of the Eulerian model with high performance,the MacCormack scheme with Total Var
【机 构】
：
School of Environment and Resource, Southwest University of Science and Technology, Mianyang 621010,
论文部分内容阅读
The random walk particle tracking (RWPT) method is compared with the Eulerian methods in investigating pollutant transport in depth-averaged flows.As a typical representative of the Eulerian model with high performance,the MacCormack scheme with Total Variation Diminishing modification (TVD-Mac) is selected for comparison.Solute concentration is simulated in four case studies.First,both numerical models have been tested in two idealized cases and compared against analytical solutions.Numerical dissipation is observed for TVD-Mac model where the concentration changes abruptly,especially under the circumstances of low resolution and misalignment between the flow direction and grid orientation.On the contrary,simulations by the random walk model achieve higher accuracy in both cases and are free of fictitious oscillations in the vicinity of sharp concentration gradients.Then,the solute oscillation along a one-dimensional hypothetical tidal estuary is simulated,with the RWPT accurately conserving mass and suffering less numerical diffusion compared with the Eulerian method.Finally,the process of pollutant transport in a Yangzte River reach is predicted by the RWPT.The longitudinal dispersion coefficient DL is calculated accordingly.It is compared favorably with the theoretical/empirical formulae,indicating the validity of the RWPT in solving complex natural problems.
其他文献
Most unsteady channel flows in nature and practical engineering appear as gradually varied ones,and in the free surface,the deformation conforms to the long wave hypothesis.One-dimensional total flow models were usually used to for the numerical simulatio
The chute aerators separate the flow from the chute bottom,and the air can enter into the flow through the lower surface.In this study,the air concentration and the pressure along the chute bottom are investigated systematically by a series of model tests
Behaviors of a prolate ellipsoid inside circular tube Poiseuille flow are studied experimentally. In the study, Reynolds number Re∈(100,700) and the confinement ratio D/A∈(1.2,2.8) are considered, where D is the diameter of the tube and A is the length of
The hydrodynamic pressure is an important load on concrete face rockfill dams (CFRDs) subjected to earthquakes,the influence of which,however,is not clear as compared with that in concrete dams.In this paper,the coupling effect between the CFRDs and the r
The presence of bridge piers in natural rivers significantly changes the flow and boundary conditions.As a consequence,ice jams can often be initiated in front of bridge piers.With the changes in flow conditions,two types of ice jam formation may appear:s
A vortex is intuitively recognized as the rotational/swirling motion of fluids,but a rigorous and universally-accepted definition is still not available.Vorticity tube/filament has been regarded equivalent to a vortex since Helmholtz proposed the concepts
An elastic model that combines the dead-end and the orifice at the downstream end is proposed in order to study the hydraulic transients during the rapid filling in small-scale pipelines with submerged outlet.In this model,the unsteady water flow is solve
Based on the computational fluid dynamics (CFD) and the experiment technology, this paper presents a new type of the twin-screw pump for the water-supply and studies its hydraulic performance with the hydraulic performance test. The internal flow characte
The wind turbines in the world\'s highest wind farm with an altitude of over 4 000 m in Naqu county of China were put into operation in 2014.Compared with the wind turbines at lower altitudes,the rated wind speed of these wind turbines are much larger,a
To study the drag reduction of a jet surface,an experiment is conducted with a gyrorotor model.The aim of this study is to analyze the influence of the jet aperture,the jet angle and the rotational velocity coupled with the jet velocity on the friction to