Effect of Lu2O3 on Charge/discharge Performances of Spherical Nickel Hydroxide at High Temperature

来源 :稀土学报(英文版) | 被引量 : 0次 | 上传用户:ydsl_0
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Nickel-metal hydride (Ni/MH) batteries are one of promising batteries for electric vehicle applications, but at high temperature the charge efficiency of nickel electrode is very low. In order to improve the high-temperature-efficiency of nickel electrode, spherical nickel hydroxide mixed with various ratios of Lu2O3 was used as active material of pasted nickel electrodes. The results of charge/discharge experiments, cyclic voltammetric measurements and XRD characterizations have shown that after addition of Lu2O3, the oxygen evolution overpotential is elevated much, the charge efficiency of nickel electrode at high temperature is greatly improved and the content of β-NiOOH phase increases in charged electrodes. In addition, the mixed ratio of Lu2O3 has different effects on high temperature performances of nickel electrode at different charge/discharge currents, 3.5 % is the optimum mixed ratio, and the action of Lu2O3 on high temperature electrochemical behaviors is more apparent when nickel electrodes are charged at small current than large current.
其他文献
Application of amorphous V2O5/carbon/neodymium oxide (Nd2O3) composite is one of ways to surmount the lower electrical conductivity of V2O5. A new type of V2O5/
The variations of electrical conductivity and hardness across the thickness of an Al alloy 7010 plate under the temper condition T7651 were investigated. The el
The joining of graphite, ceramic SiC and Cf/SiC composites via preceramic silicone resin(SR) at high temperature (800-1400℃) was studied. The curing and pyroly
An attempt has been made to study the influence of wear parameters like applied load, sliding speed, sliding distance and percentage of reinforcement on the dry
Oil-air two-phase flow measurement was investigated with a Venturi and void fraction meters in this work. This paper proposes a new flow rate measurement correl
Allylsucrose has been prepared by reaction of sucrose with allyl chloride in the NaOH-DMSO system.DS (average degree of substitution) of allylsucrose calculated
WC(27%) reinforced steel matrix composites were produced by using an electroslag melting casting technique. The microstructure of the material was characterized
The structure and electrochemical properties of the La0.7Mg0.3Ni3.4-xMn0.1Cox (x=0-1.05) hydrogen storage alloys were investigated. The crystal structure and th
The transport properties in the La2/3(Ca1-xSrx)1/3MnO3 (x=0, 1/3, 2/3) films prepared using the RF magnetron sputtering method were investigated. The effect of
Ti-50.6Ni(molar fraction, %) shape memory alloy solution treated at 850℃ for 1h followed by ageing treatment at 450℃ for 3h was studied with differential scan