滚锥是ZX系列振动器的重要零件。它的锥体部分是检测的关键项目,其加工质量直接影响振动器的性能和基本参数。近年来,各振动器厂多采用行业推荐的专用吊架检测滚锥,本文拟对这一测量方法,作初步探讨。一、图纸要求和“分等规定”以ZX50振动器为例,图纸及技术要求如图1所示。 Rolling cones are an important part of the ZX series vibrators. Its cone part is a key item of detection, and its processing quality directly affects the performance and basic parameters of the vibrator. In recent years, vibrator factories have used the special hanger recommended by the industry to detect roll cones. This paper intends to make a preliminary discussion on this measurement method. First, drawing requirements and “classification requirements” to ZX50 vibrator as an example, drawings and technical requirements shown in Figure 1.