在锥形转子装配压力弹簧①、蝶形弹簧②、支承圈③、挡圈④时,由于压紧力较大,需三个人才能完成。为此我厂革新成功了一台转子装配工具,其基本原理如图: 先将压力弹簧①、蝶形弹簧②、支承圈③套入转轴,带锥度的导向套⑤也套入转轴内,将轴用挡圈④套入导向套⑤上,然后再将压紧套⑥套入转轴,压在支承圈③上。将推进套⑨ In the conical rotor assembly pressure spring ①, butterfly spring ②, bearing ring ③, retaining ring ④, due to the pressing force is relatively large, take three people to complete. To this end, I successfully renovate a rotor assembly plant tools, the basic principle shown in Figure: First pressure spring ①, butterfly spring ②, bearing ring ③ set into the shaft, with tapered guide sleeve ⑤ also set into the shaft, the ④ shaft sleeve ④ set into the guide sleeve ⑤, and then set the sleeve ⑥ pressed into the shaft, the pressure in the bearing ring ③. Will promote sets ⑨