美国AFP自动洗片机故障排除

来源 :实用放射学杂志 | 被引量 : 0次 | 上传用户:edisonye
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
故障现象 1:在我们使用AFF90型自动洗片机时,机器内发出有规律的“格登格登”的异常声音,似胶片传动系统的机械错位,关掉机器电源,扛开机器上的盖,观察驱动电机轴杆,齿轮及辊子安放位置正常,紧固,螺丝无松动.开机检查发现响声来源于驱动杆上的齿轮与胶片干燥器上的总传动齿轮有齿轮跳动现象,但静止状态下两部分啮合严密无错位,取下胶片干燥器,机器其它部分工作正常,检查干燥器各部分,发现胶片辊子两端有锈迹,清除铁锈并滴上少许 Symptom 1: When we use the AFF90 automatic processor, a regular “Gedengeden” abnormal sound is emitted inside the machine, which is a mechanical misalignment of the film drive system. Turn off the machine’s power and open the lid on the machine. Drive motor shaft, gear and roller position is normal, tighten, no loose screws. The boot inspection found that the sound comes from the gear on the drive rod and the total drive gear on the film dryer has a gear hopping phenomenon, but the two parts in the static state Engaging tightly and without any misalignment, take off the film dryer, the other parts of the machine work normally, check the dryer parts, find rust on both ends of the film roll, remove rust and drop a little
其他文献
1941年6月22日,苏德战争爆发。德军分北、中、南三路闪击苏联,在不到一个月的时间里,德军中央集团军群的近百万大军便横扫企图阻挡住它的任何苏联红军部队,长驱直入,逼近莫
阜阳市局 £4a 局长——_MINtkMMtgj’#lnH$B——q.M——D收束志不他只邀狲位J则【科校为先导推动地租工作.B为广为戳民U用凶盼引眯B.习.互们羹宽.互狈槽竺汹IAn.刊 办好杂志。必
请下载后查看,本文暂不支持在线获取查看简介。 Please download to view, this article does not support online access to view profile.
请下载后查看,本文暂不支持在线获取查看简介。 Please download to view, this article does not support online access to view profile.
期刊
请下载后查看,本文暂不支持在线获取查看简介。 Please download to view, this article does not support online access to view profile.
SysmexF-800型血细胞分析仪反常结果的处理新疆库车解放军第十七医院检验科(842000)雷广明1.故障:(1)血小板计数反常;(2)红细胞计数反常。2。排除:(1)用滤菌器过滤稀释液即可。(2)无堵孔时,检查稀释器,看是否吸样通畅
请下载后查看,本文暂不支持在线获取查看简介。 Please download to view, this article does not support online access to view profile.
期刊
请下载后查看,本文暂不支持在线获取查看简介。 Please download to view, this article does not support online access to view profile.
请下载后查看,本文暂不支持在线获取查看简介。 Please download to view, this article does not support online access to view profile.
期刊
1 故障现象CT开机后系统指示正常、第一位患者受检时跃入检查床,将床面向扫描区强行推进15cm、即时系统报警ER114 SERVO ALARM;ALl09 TABLEDRIVER MISS、床位显示消失、出现