论文部分内容阅读
七、CD—ROM安装 CD—ROM与声卡连接如图14所示。按图将光驱与声卡的连线连接好,检查无误,给计算机加电,引导DOS,最后显示系统提示符。将光驱驱动程序安装盘放入软驱中,执行安装程序A:INSTALL或B:INSTALL并回车,根据屏幕显示信息进行安装。安装完毕后,在AUTOEXEC.BAT增加一行 C:DOSMSCDEX/D:MSCD001/M:8/V 在CONFIG.SYS增加一行DEVICE=C:SBCDSBIDE.SYS/D:MSCD001/P:170,15 重新启动计算机后发现CD-ROM已挂接成功,此时可将一张CD声盘放入CD—ROM中,在C:SBCD子目录中执行QuickCD软件,在按下播放按钮后,在喇叭中就可以听到动听的音乐了。如果想在
Seven, CD-ROM installation CD-ROM and sound card connection as shown in Figure 14. According to the figure will CD-ROM drive and sound card connection is good, check is correct, to the computer power-on, boot DOS, and finally display the system prompt. Put the CD-ROM drive installation disk into the floppy drive, execute the installation program A: INSTALL or B: INSTALL and press Enter to install it according to the screen display information. After installation, add a line to AUTOEXEC.BAT C: DOS MSCDEX / D: MSCD001 / M: 8 / V Add a line to CONFIG.SYS DEVICE = C: SBCD SBIDE.SYS / D: MSCD001 / P: 170,15 Restart your computer and found CD-ROM has been successfully linked, at this time can be a CD-ROM into the CD-ROM in the C: SBCD subdirectory of the implementation of QuickCD software in the press Play button, the speaker can hear the beautiful music. If you want to be here