论文部分内容阅读
New influence factor inducing difficulty in selective flotation separation of Cu-Zn mixed sulfide mi
【机 构】
：
State Key Laboratory of Complex Nonferrous Metal Resources Clean Utilization
【出 处】
：
矿物冶金与材料学报
【发表日期】
：
2004年期
其他文献
采用一套新颖的反重力渗流装置制备开孔泡沫铝.研究表明,采用反重力渗流法所制备的泡沫铝,表现出优良的力学性能且几乎没有渗流不足与渗流过度的缺陷；泡沫铝中的空隙度对其力
Hydrodynamic performance of an ultra deep turret-moored Floating Liquefied Natural Gas (FLNG) system is investigated.Hydrodynamic modeling of a turret-moored FL
用磷酸三丁酯(TBP)溶剂浸渍高分子交换树脂XAD-16来制备浸渍树脂.在室温下,将未稀释的磷酸三丁酯与树脂按液固比6(磷酸三丁酯体积与树脂质量比)浸渍24 h得到的浸渍树脂的质量
通过热压缩实验研究热等静压态FGH96 合金的热变形行为和微观组织演化过程.基于Gleeble- 1500,在1000～1150℃和0.001～1.0 s-1的条件下进行热压缩实验.对应力一应变数据进行拟合
采用Al含量为2％～22％(质量分数)的ZnAl钎料,配合改进型CsF-AlF3钎剂,研究ZnAl钎料在3003铝合金板材上的铺展性能及钎焊接头的力学性能与显微组织.结果表明,当Al含量低于8％时,3003
通过SEM和DSC研究添加锂对A356合金的共晶变质效果的影响.SEM显微组织观察表明:当锂的添加量为0.3％(质量分数)时,A356合金的共晶组织形貌由条片状转变为纤维状的变质效果很明
Study on a novel flat renewal supported liquid membrane with D2EHPA and hydrogen nitrate for neodymi
The Nd(Ⅲ) extraction in flat renewal supported liquid membrane (FRSLM),with polyvinylidene fluoride membrane and renewal solution including HNO3 solution as th
采用力学性能测试、慢应变速率拉伸实验,结合扫描电镜和透射电镜及电化学测试等方法,研究淬火速度对7085铝合金组织和应力腐蚀性能的影响.结果表明,随着淬火速度的降低,合金
A comparison of Ce3+ luminescence in X2Z(BO3)2 (X=Ba, Sr; Z=Ca, Mg) with relevant composition and st
The VUV-UV spectroscopic properties of Ce3+ in Ba2Mg(BO3)2,Ba2Ca(BO3)2 and Sr2Mg(BO3)2 were compared,and the relation between the energy of the 4f→5d transitio
Artificial Neural Network Ability in Evaluation of Random Wave-Induced Inline Force on A Vertical Cy
An approach based on artificial neural network (ANN) is used to develop predictive relations between hydrodynamic inline force on a vertical cylinder and some e