Numerical model and parameter investigation of transient carbon deposition in Solid Oxide Fuel Cell

来源 :2nd International Workshop on Heat Transfer Advances for Ene | 被引量 : 0次 | 上传用户：borchifish

【摘要】

：

【作者】

：

M.Zeng T.Ma M.Yan Q.Y.Chen Q.W.Wang

【机构】

：

Key Laboratory of Thermo-Fluid Science and Engineering, MOE, Xi'an Jiaotong University, Xi'an, Sha

【出处】

：

2nd International Workshop on Heat Transfer Advances for Ene

【发表日期】

：

2013年1期

【关键词】

：

Solid oxide fuel cell Carbon deposition Transient effects Modeling Parameter stu

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

　　Solid oxide fuel cells (SOFCs) allow conversion of a wide range of fuels, including various hydrocarbon fuels.The relatively high operating temperature allows for highly efficient conversion to power, fast enough internal reforming reactions, and high quality by-product heat for cogeneration or for use in a bottom cycle.

其他文献

Air-side Heat Transfer, Flow Resistance and Drainability of Modified Louver Fin Geometries

The present work was conducted to investigate the air-side pressure drop and heat transfer performance of the louver fin-tube heat exchanger for automobile applications.The fourteen kinds of louver fi

会议

CorrelationHeat ExchangerHeat transferLouver FinPressure DropDrainability

Heat Conductivity Augmentation of Polymer Materials with Artificially Designed Filler Shapes

Heat exchangers have been widely used in various industries.In many cases the operation conditions are rather harsh, and the corrosion of heat exchangers becomes a major problem.To solve this problem,

会议

A Review of ORC Development in the Past 10 Years

As long as the temperature of the exhaust stream is less than around 370℃, the thermal efficiency of the heat-to-power conversion becomes uneconomical by the employment of water-based Rankine cycle.Ac

会议

Spray Characteristics and Heat Transfer Dynamics of Cryogen Spray Cooling for the Laser Dermatology

Cryogen spray cooling (CSC) can be used in laser dermatology to prevent burning injury of skin during surgery.CSC uses a short spurt of (40 ~100 ms) on the skin surface before laser irradiation, leadi

会议

Cryogen spray coolinglaser dermatologySpray characteristicsHeat transfer dyna

Air Flow Management in a Contained Cold Aisle using Active Fan Tiles for Energy Efficient Data Cente

Generally, passive perforated tiles are used in a data center and the supplied air flow rate is under-provisioned thus the balance server air requirement is met by the hot air in the room resulting in

会议

Aisle containmentAir flow managementActive tilePassive tilePower usage effec

Thermal Design for Thermoelectric Generators for Waste Heat Recovery from Automobile Exhaust

In thermoelectric based power generation, the primary research focus has typically involved the properties of the material used in the thermoelectric material.While improving the material properties c

会议

Numerical Modeling of Depositions in Oil and Gas Industry

Presently, a significant portion of our energy is still derived from the oil and gas (ONG) industry.Until a cheaper alternate and/or near complete depletion of ONG resources, it will remain our major

会议

New Heat Exchanger Design Approach for Low Temperature Lift Heat Pump

The low temperature lift heat pump (LTLHP) utilizes a small difference between the condensing and evaporating temperatures of a working fluid.It requires a larger heat transfer area, a higher volume f

会议

Condensation in Inclined Tubes

Inclination influences the flow patterns and thus the heat transfer during condensation in smooth tubes.However, not a lot of work has been done on diabatic two-phase flows in inclined tubes which in

会议

ExperimentCondensationHeat transfer coefficientSaturation temperatureIncline

Enhanced Geothermal System: Heat Transfer and Thermodynamic Analysis

The issue about the unprecedented demand for energy has become more and more serious nowadays due to the population growth and booming industry development.The environment stresses mainly from global

会议

Numerical model and parameter investigation of transient carbon deposition in Solid Oxide Fuel Cell

与本文相关的学术论文