论文部分内容阅读
汽车灯具的透气装置有很多种,常用的有弯管式和透气膜式.弯管式透气效果好,防水、防尘效果差;透气膜式防尘、防水效果好,透气效果差.迷宫式透气装置,它克服了前两种的缺点,而且经济适用.但它的结构设计、安装方式很重要,稍微不注意就达不到预期的效果.
汽车灯具迷宫式防水透气装置
【摘 要】
：
汽车灯具的透气装置有很多种,常用的有弯管式和透气膜式.弯管式透气效果好,防水、防尘效果差;透气膜式防尘、防水效果好,透气效果差.迷宫式透气装置,它克服了前两种的缺点,而且经济适用.但它的结构设计、安装方式很重要,稍微不注意就达不到预期的效果.
【机 构】
：
湖北环宇车灯有限公司 湖北 襄阳
【出 处】
：
The 2nd International Forum on Automotive Lighting,2nd IFAL(
【发表日期】
：
2014年4期
其他文献
The vehicle headlamp assessment of light shape is necessary for road safety.Traditional testing methods using a CIE A-α type goniophotometer cost enormous amount of time and money.In this study, a fas
Necessity to Mandate Automatic Headlamp Leveling Driver perception and behaviour towards manual head
Manual Headlamp leveling in automobile is a mandatory system in India for a light source having an objective luminous flux which is less than 2,000 lumens.The purpose of this standard is to avoid glar
会议
Quantification,Assessment and Improvement of Luminance Gradient in Rear Light Roadmap toward design-
The last decade has seen huge progress in terms of light sources, molding technologies and optical simulations.The Rear combination lamps are more and more part of the customer signature, and now even
Thanks to unique styling opportunities, high energy efficiency, long lifetime and dynamic features, LED headlamps have gained a strong position in the market.Further development is ongoing at fast pac
传统的汽车前照灯光学测量方法是将车灯固定于分布式光度计,或将车灯的光分布直接投到测试墙面上测试其空间光强和照度分布.此方法的缺陷是无法直观得到车灯光能量在路面的分布情况,必须通过照度和光强的转换得到路面的照度分布情况.而由于路面的反射特性并非完全朗勃散射,导致通过上述方法测得的照度分布数据和驾驶员看到的实际亮度分布存在不一致的状况.本论文探讨了采用面式成像亮度计测量路面亮度分布的方法.通过采用CC
An AFS algorithm simulating the drivers preview behavior was studied in this research.The drivers preview change rule was studied with eight male drivers at different speed and different road curvatur
Laser headlamps are close before their first introduction into real world traffic.But before they are going to be introduced into serial application Audis laser headlamps are used in motor racing for
The vehicular illumination system has undergone considerable technological advances in recent decades such as the use of a Light Emitting Diode (LED) and HID (high intensity discharge) lamps.However,
本文介绍了两种集束照明系统的执行机构方案，通过理论计算表明了，两种方案都可以满足使用要求。两种方案的体积都比公司现有的执行机构要小了很多，原形模块总体尺寸52*95*31，方案一总体尺寸38*70*31，方案二总体尺寸44*53*33。由于方案二选用了小的电机，并且不用考虑方案一直线电机的行程问题，所以空间尺寸较小。