Polycrystalline Columnar Spherical Diamond Film Deposited Bv DC Plasma Jet CVD

来源 :Fifth International Conference on Surface Engineering(第五届表面工 | 被引量 : 0次 | 上传用户:yeximajor
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  Investigation of diamond film synthesized by chemical vapor deposition (CVD) has still attracted much attention for its outstanding properties.It would be firstly proposed to deposit spherical diamond films by DC-Plasma CVD on spherical molybdenum substrate.SEM,AFM,Raman,XRD were used to observe internal fiber texture,film quality,surface phase,respectively.Results show that the crystal grain is compact,clear,continuous and uniform.There is clear evidence of the columnar growth from the substrate surface to the diamond film surface.The diamond (111),(220),(311) peaks were clearly observed and no graphite peak was detected,which exhibited the film was an obviously polycrystalline texture.The typical Raman spectrum of diamond was found at 1332.0 cm-1 without observing characteristic peaks of polycrystalline graphite and amorphous graphite.Thus,high quality Spherical diamond films were deposited successfully.Results also indicated that grain size increases with increasing of the CH4 concentration.The evolution of the columnar growth causes enlarging the grain,which affects diamond quality.Based on the experimental observations,the low CH4 concentration was benefit of growing high quality spherical films.
其他文献
会议
会议
In this study,nonastructured Al2O3-13wt%TiO2 (AT13) coatings were deposited by multi-function micro-plasma spray and Metco 9M plasma spray,respectively.Constituent phases and the microstructure of the
he preparation of multi-layer composition gradient hard thin films on titanium aluminide was realized with a renovated arc ion plating equipment where pure titanium and aluminum separated targets had
HVOF thermal spraying tests were carried out for thermal spraying the coatings with two kinds of cermets powders,which are microstructured Sulzer Metco Diamalloy 2004 WC-12%Co powders and nanostructur
The coatings for elevated temperature erosion resistance in circulating fluidized bed (CFB) boilers were made by high velocity arc spraying process and CrB powder wire.The microstructure and phase of
PVD hard coating on various steels are well known for providing surfaces with enhanced tribological properties in terms of low friction and high wear resistance.However,their tribological performance
Thermal barrier coatings (TBCs) on the superalloy turbine blades can lower the temperature of metallic substrate by 100-300 ℃,allowing an increase in the turbine entry temperature.These coatings are g
The magnetic field distribution of the unbalance magnetron sputtering could be changed to extend the plasma area and to impose the ions to bombard the films,for that get excellent quality films.In thi
As one of the laser host materials,Nd:YVO4 has been paid more and more attention due to its features,i.e.,low lasing threshold,large absorption coefficient and high slope efficiency,which are suitable