【摘 要】
：
The spent LIBs contain lots of valuable components,such as cathode active material,aluminum(cathode current collect and LIBs casing),copper(anode current collect) and organic electrolyte.[1-3] More im
【机 构】
：
School of Chemical Engineering and Technology,Harbin Institute of Technology,Harbin 150001,P.R.China
论文部分内容阅读
The spent LIBs contain lots of valuable components,such as cathode active material,aluminum(cathode current collect and LIBs casing),copper(anode current collect) and organic electrolyte.[1-3] More importantly,Furthermore,some of batteries components are considered toxic.
其他文献
Drilling carbon fiber reinforced plastics (CFRP) products with high efficiency and quality is primary condition for applicating in aerospace industry.Diamond coated cemented carbide drills with 3mm di
The Yutu (Jade Rabbit) moon rover of China landed the moon on December 14,2013.All instruments of rover are installed on its structure, which fulfills the demands on strength and stiffness in the peri
以棕榈蜡CW为相变蓄热材料，膨胀石墨EG为添加剂，利用膨胀石墨多孔吸附及高导热特性，配比出最佳质量比为10∶1的棕榈蜡/膨胀石墨复合相变蓄热材料CW/EG.采用差示扫描量热仪(DSC)、扫描电子显微镜(SEM)及热常数分析仪(Hot Disk)，通过熔化/凝固实验及加速冷/热循环实验，对相变材料的热物性和结构进行表征.结果 表明：最佳质量配比下的棕榈蜡能被膨胀石墨充分吸附，且吸附后能保持膨胀石墨原
单斜结构的磷酸钒锂材料由于具有放电电压高、理论比容量大和安全性能好等优点,成为极富发展前景的锂离子电池正极材料之一[1].已进行的研究表明,Mg2+离子掺杂对磷酸钒锂材料的倍率性能和低温性能有明显提高[2,3].为了加快Mg2+离子掺杂的磷酸钒锂材料的工业和产业化,作者对碳热还原法制备磷酸钒锂材料的烧结工艺进行了探究,重点讨论了升温速率和保温方式对材料结构与性能的影响.
Nowadays,although Li ion battery technology is sufficient to power small portable devices such as mobile phones and lap-top computers,significant challenges in the specific capacity and rate capabilit
本文通过共沉淀-冷冻干燥法制备高倍率锂离子电池Li1.2Mn0.6Ni0.2O2正极材料.所制备的纳米 富锂锰基正极材料颗粒分布均匀,粒径约200-300 nm.充放电数据显示,在5C时,首次放电比容量 为155.3 mAhg-1,50周充放电循环后,容量仍高达131 mAh g-1.
层状镍钴锰三元正极材料LiNixCoyMn1-x-yO2(0＜x,y＜l)作为新一代锂电池正极材料的研究热 点之一,具有容量高、热稳定性好、价格相对低廉、毒性相对较低等优点,将逐渐取代传统的LiCoO2 正极材料.
Here,Li1.2Mn0.54Ni0.13Co0.13O2 materials have been prepared by solid state reaction method by adding 3,4-Dihydroxyphenylaceticacid(C8H804) and tartaric acid(C4H606) as organic additives.
银是粗铜中典型的正电性杂质之一.由于国家标准(GB/T 467-2010)对阴极铜中银含量的要求 较宽泛(要求低于25ppm),大部分铜冶炼企业所用阳极铜的银含量也不高,一般为0.08 ％～0.15 ％,正常生产时阴极铜的银含量基本维持在15ppm以下,均能达到此要求.
A group of cyclic voltammetry tests were designed to determine the influence of chromic acid concentration to Cr(Ⅵ) eletrodeposition,with chromic acid concentration ranging from 0.1 g/L to 50 g/L.