Laser Diode Array side-pumped Nd∶YAG ultra-short pulse regenerative amplifier

来源 :LIMIS 2016——The 4th International Symposium on Laser Interac | 被引量 : 0次 | 上传用户:hubeibei1919
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  A laser diode array side-pumped ultrashort pulse Nd∶YAG rod gain medium regenerative amplifier system is demonstrated.
其他文献
Power balance is an important factor to implement symmetrical compression in ICF.This paper has studied the waveform loop control for power balance,and put forward the idea of realizing waveform loop
In high power laser facility,multichannel composite temporal profile measurement system,which combines time-division multiplexing technology with digital oscilloscope channels,is based on single mode
High power narrow linewidth fiber lasers have recently attracted a great deal of interest due to their unique properties and potential wide applications in coherent detection,gravitational wave detect
This paper presents the experimental results on the laser beam transfer from air to under seawater.Some parameters such as the radiance,the scintillation index,and the correlation of different signals
As two main atomic alkalis,rubidium (Rb) and cesium (Cs) have the similar energy-level structures and physical features.
The repetitive-pulsed non-chain HF laser is characteristic of high repetition rate,high beam quality and compact structure,and because of HF lasers emission spectrum of 2.6~3.1μm,it becomes as one of
The final optics assembly (FOA) holds the last and individually most expensive large optics in large high-power lasers.These optics operate at a high laser fluence level and are prone to optical damag
We reported a high efficient and high power continuous wave (CW) 1064 nm laser with a Nd∶YAG single crystal fiber.The pumping source was a 200 W CW laser diode which was fiber-coupled (NA=0.22,Dcore=0
XeF(C-A) excimer laser is a potential optical source in the visible region because of its broad spectral bandwidth of about 40nm FWHM centered at 480nm.
The output pulse should be shaped and the spatial distribution should be flattened in ICF laser facility in order to satisfy the requirement of physical experiment and to ensure the facility operation