2. 您的位置
3. 首页
4. 会议论文
5. Based on fine plait piercing technology of the steel matrix stiffness optimization of finite element

Based on fine plait piercing technology of the steel matrix stiffness optimization of finite element

来源 :第二届中国国际复合材料科技大会 (CCCM-2) | 被引量 : 0次 | 上传用户：devil521zhou

【摘 要】

：

This paper briefly describes the characteristic of fine weave pierced fabric, which is pre-disposing needle array in Z direction and integrated piercing woven fabrics in X-Y direction.This paper also

【出 处】

：

第二届中国国际复合材料科技大会 (CCCM-2)

【发表日期】

：

2015年7期

【关键词】

：

fine weave piercing model of element the overall stiffness of the steel matrix t 

下载到本地 , 更方便阅读

下载此文 赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

　　This paper briefly describes the characteristic of fine weave pierced fabric, which is pre-disposing needle array in Z direction and integrated piercing woven fabrics in X-Y direction.This paper also studies the mutual effect between woven fabrics and needle array in forming process.

其他文献

Effects of different carbon sources on the compressive proprieties of in situ high-volume-fraction T

Effects of carbon sources, i.e., carbon nanotubes (CNTs), graphite, carbon black (C-black), on synthesized TiCx size, morphology and compressive properties of in situ 40-60 vol.% TiCx/2009Al composite

会议

Effects of different surface-modified SiCP on the microstructures and tensile properties of SiCP/201

The pre-oxidized SiO2 layer and salt-bath plated Ti5Si3 coating layer were developed on the surface of SiCP.Effects of surface states of SiCP on the microstructures and tensile properties of 2 vol.% S

会议

SiCP/2014Al compositesSurface modificationMicrostructureTensile properties

Piezoelectric properties of rhombohedral ferroelectric materials with phase transition

The temporal evolution of domain structure and its piezoelectric behavior of ferroelectric material BaTiO3 during the transition process from rhombohedral to tetragonal phase under an applied electric

会议

Ferroelectricsrhombohedraltetragonalmonoclinicphase transitionpiezoelectric

The bistable behavior of temperature-sensitive gel-based composite structure

Temperature-sensitive gels can produce volume transition phenomenon in the vicinity of phase transition temperature, leading to their wide application in many engineering fields.According to the volum

会议

The tensile properties at elevated temperature of Al2014 matrix composites reinforced with nano-and

Bimodal sized (Nano-SiCp: n and Micro-SiCp: m) SiCp/Al2014 composites with different volume percent of particles (0.5n + 4m, 0.5n + 6m, 1n + 4m) were fabricated by semi-solid stirring combined with ho

会议

碳纤维表面原位金属化工艺研究

在高温、氢氛下使纤维表面铜盐涂层还原为铜， 通过XRD、SEM和EDS对纤维表面镀层形貌和成分进行了观察与分析，获得的碳纤维表面铜层呈现粒状连续分布，与纤维表面结合过程具有物理和化学的共同特点。

会议

碳纤维金属化原位热还原

Tribological properties of Fe-Ni matrix composites with MoS2/reduced graphene oxide at elevated temp

In this study, MoS2/reduced graphene oxide hybrid material (MoS2/RGO) was synthesized through a facile and effective hydrothermal method.Fe-Ni matrix composites with different weight fractions of MoS2

会议

MoS2/RGOhybrid structureFe-Ni matrix compositestribological propertyhigh tem

三维编织石英纤维预制体压缩回弹性能试验研究

针对航天密封材料的使用特性,引入了三维编织结构石英纤维预制体作为热密封件。室温下测试了三维编织结构石英纤维预制体的单向压缩、循环压缩和应力松弛性能。试验结果表明：三维编织结构预制体具有良好的可压缩性,压缩应变可达到60％；循环压缩的首次压缩变形后瞬时能够达到近似完全回弹,峰值载荷随后续循环次数的增加呈非线性降低,10次压缩循环后,回弹率一般仍可达到70％以上；应力松弛曲线分为两个阶段：快速松弛阶段

会议

热密封三维编织石英纤维压缩性能应力松弛

复合材料曲型加筋板的建模方法和自由振动

针对复合材料曲型加筋板，基于有限单元法，研究了其建模方法和自由振动。基于层合板理论，及Mindlin-Reissener板理论，对复合材料层合板进行建模；同时基于Timoshenko梁理论，对曲型加强筋进行建模。曲型加强筋可任意铺设在板上，而无需与板共节点。同时当筋的数量位置发生改变时，无需对板进行再次划分网格。

会议

复合材料曲型加筋板有限单元法建模方法自由振动

铺层方式对复合横担中复合材料管承载力影响的研究

本文通过有限元软件msc.marc对不同铺层结构的复合材料管进行屈曲分析，并对500kV复合横担塔进行受力分析，得出左横担中支柱绝缘子所受的最大轴力和弯矩，并将轴力和弯矩分别加载至支柱绝缘子的实体模型中，计算不行铺层结构各层最大应力，得出相关结论.

会议

支柱复合绝缘子铺层结构复合横担