论文部分内容阅读
阐述了胶带机在提供相关运行参数条件下,通过分析计算传动滚筒带动皮带运转所需要的主要九种运行阻力,得到驱动圆周力,从而算出驱动滚筒的输出轴功率,得到实际电机功率。根据实际电机功率,再进行电机的适当选型。通过分析计算,确保传动滚筒不打滑和胶带垂度为1%时的各段最小张力,从而逐步对胶带各部分张力的计算,最终得到配重重量,然后再进行配重具体标定。
The paper analyzes the main nine kinds of running resistances required by the belt driving belt driven by the belt conveyor under the condition of providing relevant operating parameters and obtains the driving circular force so as to calculate the output shaft power of the driving drum and obtain the actual motor power. According to the actual motor power, then the appropriate selection of the motor. Through the analysis and calculation, to ensure that the transmission roller does not slip and the tape when the dip of 1% of the minimum tension when the tension in order to gradually calculate the tension of each part of the tape, the final weight of the weight, and then weight specific calibration.