Influence of deformation on microstructure and properties of as-quenched AA5083 plate

来源 :15th International Conference on Aluminium Alloys(ICAA15)(第十 | 被引量 : 0次 | 上传用户:nihaosww
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The cold rolling deformation on microstructure, strength, elongation, corrosion properties are investigated in as-quenched AA5083 plate.It shows that large deformation rusults in work hardening and more stored energy to make it easy to recrystallize at lower temperature and more nucleation, therefore smaller size of recrystallization and higher plasticity.
其他文献
In this study we focused on the influence of nano-size B4C particles (~60 nm) on microstructure and mechanical behavior of Al-2024/B4C composites.The experiment involved ball milling of 2024-Al and B4
会议
Al-Zn-Mg alloys are widely used in aircraft and automotive industries for structure components because of exceptionally high specific strength in the fully aged condition.Precipitation sequence for Al
会议
Dispersoids play a significant role in the recrystallization and texture development for wrought Al-Mg-Si (6xxx series) alloys by inhibiting grain boundary motion.It is therefore important to understa
会议
Al-7 wt% Si ahoy was treated by the high pressure solution (2 GPa) and natural aging, and precipitation behavior of the dispersoids in the alloy was investigated through TEM to provide a possible form
会议
In this study the influence of natural aging in energy absorbance capacity of 6xxx series extruded profiles after artificial aging is examined by means of optical and scanning electron microscopy, qua
会议
The solution process of a Al-Mg-Si alloy is heated by electric resistance wire and hot air respectively.Specimens were performed at 560℃ for 30 min and then cooled by water quenching.Immediately, the
会议
In this paper, 40 mm thick A7N01-T5 aluminum alloy plate was friction stir welded using a double side process.The microstructure evolution of different zones of the joint, which is significantly affec
会议
In recent years, energy saving and environmental protection have caused widespread concern.Using the aluminum alloys for the vehicle can reduce the weight of the vehicle to reduce energy consumption.6
会议
The recrystallization kinetics at 530℃ of twin roll casting Al-Mn alloys with and without low temperature pre-recovery was investigated.It was revealed that the samples with/without pre-recovery exhib
会议
The wrought Al-Mg alloys, commercially designated as 5000 series, have been widely applied as a form of sheet or plate to various industries such as automotive, shipbuilding, construction, beverage ca
会议