Onboard actuator model-based Incremental Nonlinear Dynamic Inversion for quadrotor attitude control:

来源 :中国航空学报(英文版) | 被引量 : 0次 | 上传用户:zwb20042002
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
This paper addresses the robust attitude control problem for quadrotors subject to model mismatch and disturbances.A dynamic inversion based attitude control scheme is proposed,which consists of an outer loop attitude controller and an inner loop angular acceleration con-troller.The attitude controller is designed based on the Nonlinear Dynamic Inversion (NDI) to pre-cisely linearize the nonlinear dynamics between the angular acceleration and the attitude.An onboard actuator model-based Incremental Nonlinear Dynamic Inversion (INDI) controller is designed in the angular acceleration control loop to improve the robustness against the model mis-match and disturbances.Meanwhile,the onboard actuator model with a modified structure elimi-nates the oscillation phenomenon when the sampling rate of the controller is higher than that of the actuator.Numerical simulations and flight tests demonstrate the effectiveness and robustness of the proposed controller in comparison with the PID controller.
其他文献
文章对辽宁省旱涝成因以及前期海温外强迫特征进行了剖析。研究表明辽宁夏季降水存在显著的季节内特征,初夏主要受东北冷涡的影响,两者之间存在显著负相关关系。初夏东北冷涡强度指数与两个海温关键区的相关系数,分别为0.38和0.45,均超过信度为0.01的检验。
The low-speed wind tunnel experiment is carried out on a simplified aircraft model to explore the influence of wing flexibility on the aircraft aerodynamic performance.The investigation involves the measurements of force,membrane deformation and velocity
SiCp/Al composites are difficult-to-cut materials.In recent years,electrical arc discharge machining has been developed to improve the machinability of these materials.However,there is a big challenge to build a satisfactory heat transfer model of SiCp/Al
Electrically Controlled Rotor (ECR),also called as swashplateless rotor,applies blade pitch inputs via trailing-edge flaps system instead of traditional swashplate mechanism.In addition to primary control,rotor vibration reduction and noise alleviation ar
The present study performed a numerical investigation to explore the performance enhancement of a co-flow jet (CFJ) airfoil with simple high-lift device configuration,with a specific goal to examine the feasibility and capability of the proposed configura
Emissions produced by the aviation industry are currently a severe environmental threat;therefore,aviation agencies and governments have set emission targets and formulated plans to restrict emissions within the next decade.Hybrid aircraft technology is b
In this paper fretting fatigue crack behavior in 1045 steel is studied by in-situ observation and finite element analysis,in-situ fretting fatigue experiments are conducted to capture real-time fretting fatigue crack formation and propagation process.The
Reasonable and effective fatigue load spectrum is key of aircraft structural fatigue test.Two kinds of load spectra simplification approaches based on statistical consistent fatigue damage model are proposed in the paper.One method is to simplify the orig
The multiple jets impingement heat transfer is widely applied in the wing anti-icing sys-tem.It is challenging to apply the similarity criterion to carry out the anti-icing experiments due to the complex flow and heat transfer behavior.In the present stud
Research on the transition phase of tail-sitter Unmanned Aerial Vehicles (UAVs) is cru-cial for trajectory planning and performance analysis.This study focuses on the analysis of the tran-sition characteristics and path of a small dual-rotor tail-sitter U